HVACopediaAll brands · Heat pump troubleshooting
Service problem analysis (Amana chart excerpt)
What is going on
Possible causes and checks for: service problem analysis (amana chart excerpt).
Likely causes
- Will not start: power failure (test voltage), blown fuse (check type/size), loose connection, shorted/broken wires (ohm circuits), open overload (continuity). Chart columns: no heat/cool, no cooling, no heating, compressor runs/won't run, head pressure high/low, suction high/low, etc. — book shows only fragment
- Manufacturer chart required
More heat pump guides
- 2 flashes: HPS open ≥6 s; 3: discharge >263°F; 4: discharge <90°F after 1 h; 5: defrost failure; 6: discharge sensor short; 7: outdoor sensor open/short; 9: bonnet sensor fail
- Excess ice on outdoor coil
- Extremely high head pressure in heating (dual fuel)
- Insufficient heat in cold weather
- Liquid slugging / compressor damage in heating
- No mode change / wrong mode
Take it to the job
All guides, error codes and tips work offline in the HVACopedia app.
Source: General HVAC service practice — verify per model. Written in our own words; check the manual for your exact model.
For licensed technicians. Gas, electrical and refrigerant work must be done by a qualified, licensed person. Shut off power and gas before servicing, never bypass a safety control, and follow the manufacturer’s manual for the exact model; it and local codes always take priority. HVACopedia is not affiliated with any manufacturer; brand and model names only identify the equipment.