HVACopedia

Gree · Heat pump

8°C 8 degC heating mode active

Normal status Gree SapphireGree Livo GEN4Gree Vireo GEN3

What the display is showing

In heating mode, pressing TEMP and CLOCK together shows a heating icon and 8°C (46°F with Fahrenheit display) on the remote. The unit then holds an 8°C set point with the fan fixed on auto. Sleep and this mode cancel each other. Not a fault.

Applies to: Gree Sapphire 9-24k (SAP..HP230V1A); Livo GEN4 30-36k (4LIV..HP230V1A); Vireo GEN3 9-24k (3VIR..HP115/230V1A)

What to do

  1. Heating mode press TEMP and CLOCK together to start.
  2. Press them together again to leave it.

Models that show this code

12 models in Gree Sapphire, Gree Livo GEN4, Gree Vireo GEN3

3VIR09HP115V1A3VIR09HP230V1A3VIR12HP115V1A3VIR12HP230V1A3VIR18HP230V1A3VIR24HP230V1A4LIV30HP230V1AH4LIV36HP230V1AHSAP09HP230V1AHSAP12HP230V1AHSAP18HP230V1AHSAP24HP230V1AH

Other codes on the same units

  • 88 Sleep curve editing (remote)
  • C5 Jumper (capacity) cap missing or bad
  • E1 High pressure protection
  • E2 Indoor coil freeze protection (status)
  • E3 Low pressure protection
  • E4 Compressor discharge temperature too high
  • E5 Overcurrent protection (whole unit)
  • E6 Indoor/outdoor communication fault

Save it for the next call

Star this code in the HVACopedia app and keep the whole library on your phone for jobs with no signal.

Open the app

Source: Gree Sapphire 9-12k (SAP09-12HP230V1A) service.pdf - section 6.1 remote controller, combination buttons; Gree Sapphire 18-24k (SAP18-24HP230V1A) service.pdf - section 6.1 remote controller, combination buttons; Gree Livo GEN4 30-36k (4LIV30-36HP230V1A) service.pdf - section 6.1 function introduction for combination buttons; Gree Vireo GEN3 9-24k (3VIR..HP115-230V1A) service GREE_VIREOGEN3_SERVICE_090921.pdf - section 6.1 function introduction for combination buttons. Summarized in our own words; check the original manual for your model.

For licensed technicians. Gas, electrical and refrigerant work must be done by a qualified, licensed person. Shut off power and gas before servicing, never bypass a safety control, and follow the manufacturer’s manual for the exact model; it and local codes always take priority. HVACopedia is not affiliated with any manufacturer; brand and model names only identify the equipment.