HVACopediaKinghome · Heat pump
P1 Compressor rated-frequency test display
What the control is telling you
Not a fault: shown while the unit runs the nominal cooling or heating test.
Applies to: Kinghome KM09HT1DI, KM12HT1DI, KM18HT1DI, KM24HT1DI wall mini-splits; Kinghome KM09HF1DI to KM24HF1DI wall mini-splits (Gree GFH..DA/DB)
Likely causes
- Test mode active
Test and repair steps
- Exit the test mode.
Models that show this code
9 models in Kinghome KM HT1DI, Kinghome KM HF1DI
Other codes on the same units
- H6 Fan motor feedback fault (indoor or outdoor)
- H7 Compressor out-of-step
- L3 Outdoor DC fan motor fault
- L9 Power limit protection
- P0 Compressor minimum-frequency test / driver reset
- P2 Compressor maximum-frequency test display
- P3 Compressor intermediate-frequency test display
- P5 Compressor phase overcurrent
Save it for the next call
Star this code in the HVACopedia app and keep the whole library on your phone for jobs with no signal.
Source: Kinghome KM09-12-18-24HT1DI service manual, sec. 9.1 error code list; Kinghome KM09-24HF1DI service manual, sec. 11.1 error code list. Summarized in our own words; check the original manual for your model.
Homeowner looking at this code? See what it means for you and when to call a technician.
For licensed technicians. Gas, electrical and refrigerant work must be done by a qualified, licensed person. Shut off power and gas before servicing, never bypass a safety control, and follow the manufacturer’s manual for the exact model; it and local codes always take priority. HVACopedia is not affiliated with any manufacturer; brand and model names only identify the equipment.