HVACopedia

Bosch · Heat pump

F1 High pressure switch protection

High severity Bosch IDS LightBosch IDS Premium Connected

What the control is telling you

The high pressure switch has opened.

Applies to: Bosch IDS Light BOVA15-24/36/60 and IDS Premium Connected BOVA36-20/60-20 R-454B heat pump outdoor units

Likely causes

  • Overcharge or non-condensables
  • Poor connection at CN10
  • Failed switch

Test and repair steps

  1. Check connection at CN10 and wiring.
  2. Check charge for overcharge or non-condensable gas.
  3. Replace the high pressure switch; then the control board if needed.

Models that show this code

5 models in Bosch IDS Light, Bosch IDS Premium Connected

BOVA15-24BOVA15-36BOVA15-60BOVA36-20BOVA60-20

Other codes on the same units

  • E45 Th temperature sensor fault
  • E51 Input voltage out of range
  • E52 DC bus voltage out of range
  • E81 EEV coil fault
  • F2 System lockout (5 low-pressure trips in 100 minutes)
  • F4 Pressure transducer fault
  • F41 High pressure sensor fault
  • F42 Low pressure sensor fault

Save it for the next call

Star this code in the HVACopedia app and keep the whole library on your phone for jobs with no signal.

Open the app

Source: Bosch IDS Light installation BTC 762003308 D (02.2025), Fault Code Table 23 and 17.12 Error Code Troubleshooting, p.42-59; Bosch IDS Premium Connected installation BTC 762003301 D (02.2025), Fault Code Table 22 and 18.12 Error Code Troubleshooting. Summarized in our own words; check the original manual for your model.

Homeowner looking at this code? See what it means for you and when to call a technician.

For licensed technicians. Gas, electrical and refrigerant work must be done by a qualified, licensed person. Shut off power and gas before servicing, never bypass a safety control, and follow the manufacturer’s manual for the exact model; it and local codes always take priority. HVACopedia is not affiliated with any manufacturer; brand and model names only identify the equipment.