HVACopediaNTI · Boiler
Lockout 257 Controller interaction enable does not match neighbor stack fault setting
What the control is telling you
Controller interaction enable does not match neighbor stack fault setting.
Applies to: Trinity Tft60, Tft85, Tft110, Tft154, Tft201, Tft285, Tft340, Tft399
Models that show this code
13 models in Trinity Tft
Other codes on the same units
- Lockout 253 Lead Lag modulation sensor not valid with setpoint source
- Lockout 254 Lead Lag modulation sensor not valid with local setpoint source
- Lockout 255 Lead Lag modulation sensor not valid with local modulation source
- Lockout 256 Selected Controller interaction enable setting is not allowed
- Lockout 258 Controller ID must be non-zero if controller interaction is enabled
- Lockout 259 Modulation output must be fan if controller interaction is enabled
- Lockout 260 Asymmetrical paired (no flap) is set but flap switch input is energized
- Lockout 261 Neighbor burner control blower fault detected
Save it for the next call
Star this code in the HVACopedia app and keep the whole library on your phone for jobs with no signal.
Source: NTI Trinity Tft399 Installation and Operation Manual (2018-09-07), Sec. 16.0 Troubleshooting, Table 16-3. Summarized in our own words; check the original manual for your model.
Homeowner looking at this code? See what it means for you and when to call a technician.
For licensed technicians. Gas, electrical and refrigerant work must be done by a qualified, licensed person. Shut off power and gas before servicing, never bypass a safety control, and follow the manufacturer’s manual for the exact model; it and local codes always take priority. HVACopedia is not affiliated with any manufacturer; brand and model names only identify the equipment.