HVACopediaNTI · Boiler
Lockout 241 Exchanger sensor not allowed with stack connector setting
What the control is telling you
Exchanger sensor not allowed with stack connector setting.
Applies to: Trinity Tft60, Tft85, Tft110, Tft154, Tft201, Tft285, Tft340, Tft399
Models that show this code
13 models in Trinity Tft
Other codes on the same units
- Lockout 238 Invalid Stack connector type setting
- Lockout 239 Invalid Header connector type setting
- Lockout 239 Invalid Header connector type setting
- Lockout 240 Invalid Outdoor connector type setting
- Lockout 242 Invalid DHW auto detect configuration
- Lockout 244 PFEP Internal fault: Safety relay test invalid state
- Lockout 245 Invalid Outlet connector type setting for T-rise
- Lockout 246 4-20mA cannot be used for both modulation and setpoint control
Save it for the next call
Star this code in the HVACopedia app and keep the whole library on your phone for jobs with no signal.
Source: NTI Trinity Tft399 Installation and Operation Manual (2018-09-07), Sec. 16.0 Troubleshooting, Table 16-3. Summarized in our own words; check the original manual for your model.
Homeowner looking at this code? See what it means for you and when to call a technician.
For licensed technicians. Gas, electrical and refrigerant work must be done by a qualified, licensed person. Shut off power and gas before servicing, never bypass a safety control, and follow the manufacturer’s manual for the exact model; it and local codes always take priority. HVACopedia is not affiliated with any manufacturer; brand and model names only identify the equipment.