HVACopediaNTI · Boiler
Alert 361 Internal error: No factory parameters were detected in control
What the control is telling you
Control board logged an internal error: No factory parameters were detected in control.
Applies to: Trinity Tft60, Tft85, Tft110, Tft155, Tft175, Tft200, Tft250, Tft300, Tft399
Models that show this code
13 models in Trinity Tft
Other codes on the same units
- Alert 359 Abnormal Recycle: fault inlet sensor
- Alert 36 Program Module (PM) incompatible with product was inserted into socket
- Alert 36 Program Module (PM) incompatible with product was inserted into socket
- Alert 360 Abnormal Recycle: Check Parameters Failed
- Alert 362 Internal error: PID iteration frequency was invalid
- Alert 363 Internal error: Demand-Rate interval time was invalid
- Alert 364 Internal error: Factory calibration parameter for modulation was invalid
- Alert 365 Internal error: CH PID P-scaler was invalid
Save it for the next call
Star this code in the HVACopedia app and keep the whole library on your phone for jobs with no signal.
Source: NTI Tft60-399 Installation and Operation Instructions (rev. 2012-04-09), Sec. 15.0 Troubleshooting, Table 15-4. Summarized in our own words; check the original manual for your model.
Homeowner looking at this code? See what it means for you and when to call a technician.
For licensed technicians. Gas, electrical and refrigerant work must be done by a qualified, licensed person. Shut off power and gas before servicing, never bypass a safety control, and follow the manufacturer’s manual for the exact model; it and local codes always take priority. HVACopedia is not affiliated with any manufacturer; brand and model names only identify the equipment.